WinNT Setup

Install windows from usb or boot cd

IF yellow  at PBR , you must convert disk 

To change a dynamic disk back to a basic disk using a command line

  1. Back up all volumes on the disk you want to convert from dynamic to basic.
  2. Open a command prompt and type diskpart.
  3. At the DISKPART prompt, type list disk. Note the disk number you want to convert to basic.
  4. At the DISKPART prompt, type select disk <disknumber>.
  5. At the DISKPART prompt, type detail disk <disknumber>.
  6. For each volume on the disk, at the DISKPART prompt, type select volume= <volumenumber> and then type delete volume.
  7. At the DISKPART prompt, type select disk <disknumber>, specifying the disk number of the disk that you want to convert to a basic disk.
  8. At the DISKPART prompt, type convert basic.

 

 

tested on vm , you must integrade driver for vm hd ; if not  boot will be failed .

Leave a comment

Your email address will not be published. Required fields are marked *